Block Molding/Quick Semi Auto/Technical Parameters-

Block Molding Quick Semi Automatic 1Features
April 29, 2019
BLOCK MOLDING>QUICK SEMI AUTOMATIC/DEVICE CONFIGURATION
April 29, 2019
Show all

Block Molding/Quick Semi Auto/Technical Parameters-

I. Relevant Technical Data

1. Production Capacity Table (unit: ten thousand pieces)

  1. Table of Partial Technical Parameters of Molding Machine

    3. Molding cycle: 15S (secondary surface material need to increase 5-8S).

    4. Vibration frequency: 2900-3400r/min (motor variable-frequency vibration).

    5. Exciting force: 100-120KN;

    6. Rated working pressure: 12-25Mpa.

    II. Requirements of Raw Materials

    The equipment is of good adaptability to the raw materials, and the requirements of using fly ash and other industrial residues as raw materials are considered.

    1. Cement shall comply with GB 175, GB/T 2015.

    2. Fine aggregate shall comply with GB/T 14684.

    3. Coarse aggregate: gravel and pebble shall comply with GB/T 14685, and heavy slag shall comply with YBJ 20584. In case of furnace bottom slag and ash are discharged in a mixed way, the loss on ignition of the remainder after sieving with a 0.16mm sieve shall not exceed 15%.

    Aggregate chips: the fine aggregate powder content of aggregate chips less than 0.16mm shall not exceed 20%.

    4. Admixture: fly ash shall comply with GB/T 1596 and GB 6566, and blast furnace slag powder shall comply with GB/T 18046.

    5. Lightweight aggregate shall comply with GB/T 17431.

    6. Additive shall comply with GB 8076 and JC 474.

    III. Product Quality

    The products produced with this production line shall comply with the appropriate standards of the People’s Republic of China.

    1. Hollow Block

    Size: 390×190×190mm

    Quality: compressive strength higher than 10Mpa (a certain amount of fly ash can be added, and the ratio is about 30%)

    2. Multi-hole Brick

    Size: 240×115×90mm

    Quality: compressive strength higher than 15Mpa (a certain amount of fly ash can be added, and the ratio is about 30%)

    3. Solid Brick

    Size: 240×115×53mm

    Quality: compressive strength higher than 15Mpa (a certain amount of fly ash can be added, and the ratio is about 30%)

    4. Color Paving Brick

    Size: 200×100×60mm

    Quality: compressive strength higher than 30Mpa